Hyundai power products HYRM1000, Инструкция по эксплуатации

Страница: 21 / 48

21
Assembly & Installation
Charging The Battery
The mower is supplied with a partially charged
battery. As soon as the dock station is
connected, you can charge the battery.
Installing The Boundary Wire
STEP 1
If you want to adjust the boundary wire in the
future then it is preferable to peg down the
boundary wire, water the area to make it
easier to insert the pegs.
STEP 2
If you don’t want to insert the pegs, you can
bury the wire 15mm below the surface, or you
can combine both methods.
STEP 3
Laid in a loop around mower’s working area.
It is preferable to begin burying wire from one
end of the dock station, then the boundary
wire round the working area, to the other end
of dock station.
Lay the cable from here: Or from here:
STEP 4
The boundary wire should be laid 35cm from
the area edge, obstacle, fence, flower bed etc.
This will prevent the mower from colliding with
the obstacle and will reduce the lawnmower
body wear.
STEP 5
When there are several working areas, the
width of the passage connecting the areas
must be over 1.2m. Otherwise, it is difficult for
the mower to move into another area. If you
have a swimming pool, please leave 2m
between the edge and the limit as a path.
STEP 6
At the corners, do not lay the boundary wire
at a sharp or right angle. Make sure it has a
35cm space from the wall or other obstacles;
an arc with a radius at least 50cm is
preferable.
On the next page is a general guide line map
showing how to install the lawnmower
including placement of the dock station and
installation of the boundary wire.