Hyster H177, Периодическое техническое обслуживание

Страница: 71 / 80

8000 SRM 707 Wheel and Tire Replacement
STEP 3.
Turn over rim and tire. Put blocks under rim so rim
is 8 to 10 cm (3 to 4 in.) above floor. Install flange
seat (if used) and lock ring.
STEP 4.
Put lock ring in the correct position on rim. Add air
pressure to tire as described in Add Air to Pneumatic
Tires.
Install Tire on Two-Piece Wheel
WARNING
Wheels can explode and cause injury or death
if the following procedures are not followed:
• Clean and inspect all parts of the wheel be-
fore installing the tire.
• DO NOT use any damaged or repaired wheel
parts.
• Make sure all parts of the wheel are the cor-
rect parts for that wheel assembly.
• DO NOT mix parts between different types or
manufacturers of wheels.
• DO NOT mix types of tires, type of tire tread,
or wheel assemblies of different manufactur-
ers on any one lift truck.
Do not use a steel hammer on the wheel. Use
a rubber, lead, plastic, or brass hammer to put
parts together. Make sure the side ring is in the
correct position. The ends of the side ring must
not touch. The clearance at the ends of the lock
ring will be approximately 13 to 25 mm (0.5 to
1.0 in.) after it is installed. If the clearance is
wrong, the wrong part has been used.
CAUTION
Do not use pneumatic shaped solid tires on
two-piece bolt together drive wheels.
Spin-
ning may occur.
1. Clean and inspect all parts of wheel. Paint any
parts that have rust or corrosion.
2. Install new inner tube in tire. Used tubes and
flaps can cause tire failure.
WARNING
Do not lubricate the tire bead with antifreeze
or petroleum-based liquid. Vapors from these
liquids can cause an explosion during inflation
or use.
3. Apply a rubber lubricant or a soap solution to tire
bead and tube.
4. Install new tire flap.
5. Make sure rim is the correct size for tire. Lubri-
cate part of wheel that contacts bead and flap.
65