Steambrite Supply
Steambrite Supply
Created on: : Monday 20 September, 2021
>
11. Position the Cam Bearing Support Tool with the
bolt head down over the Safety Cover opening on
the pump body.
Figure 19
Figure 20
Plastic Valve
Cage points Up.
12. Turn the bolt down by hand until it comes in contact
with the Cam Bearing.
13. Use the arbor press ram to press down on the bolt
in the Cam Bearing Support Tool to push the front
Main Bearing into the pump bearing bore until it
comes in contact with the first retaining ring on the
crankshaft.
14. Turn the pump over to install the Retaining Ring in
the pump bearing bore.
Valve Assembly Installation
1. Lubricate the Pump Body Valve Bores.
2. Install the Valve Assemblies into the INLET side
valve bores with the plastic valve cage portion facing
UP (See Figure 20).
3. Install the Valve Assemblies into the OUTLET side
valve bores with the metal valve seat portion facing
UP (See Figure 21).
4. Apply a small amount of grease to the top and bottom
inside surfaces of the Connecting Rod. (The
area where the Cam Bearing comes in contact
with the Connecting Rod.)
-10-
5. Place the Connecting Rod on the Cam Bearing.
Metal Valve
Seat Points up.
Figure 21
Cylinder Sleeve and Piston Stack
Installation (Series 5300X and 5324 only)
NOTE: Clean the cylinder sleeves using the
Burnishing Adapter provided with the tool kit. The
Burnishing Adapter is to be mounted on an electric
motor shaft.
1. Insert the Cylinder Sleeve (Brass Retainer End
out) into the Burnishing Adapter and polish the
inside surface using a No. 320 grit emery cloth.
2. Use a wire brush to clean the outside of the
Cylinder Sleeve.
NOTE: Upon inspection, if pitting or scratches still
show on the inside of the Cylinder Sleeve, the
Cylinder Sleeve and the Cylinder Sleeve O-ring
should be replaced.
3. Insert the Cylinder Sleeve into the cylinder bore of
the Pump Body.
Steambrite Supply - 210 662 9000 - [email protected] Page 15/32
