Hypertherm MAXPRO200, Инструкция по эксплуатации

Страница: 94 / 105

90 MAXPRO200 Instruction Manual 807700 Revision 1
Operation
Install and inspect consumables
Install consumables
Check the consumable parts daily for wear before cutting. See Inspect consumables on page 91. Before removing
consumables, bring the torch to the edge of the cutting table, with the torch lifter raised to its highest point to prevent the
consumables from dropping into the water of the water table.
Do not overtighten parts! Only tighten until mating parts are seated.
WARNING!
Always disconnect power to the power supply before inspecting or changing torch consumable parts.
Use gloves when removing consumables. The torch might be hot.
Apply a thin film of silicone lubricant on each o-ring. The o-ring
should look shiny, but there should not be any excess or built-up
lubricant. Wipe the internal and external surfaces of the
torch with a clean cloth or paper towel.
1. Install the
electrode into
the torch head
2. Install the swirl
ring into the
nozzle
3. Install the
nozzle and swirl
ring into the
nozzle retaining
cap
4. Install the
nozzle retaining
cap onto the
torch head
5. Install the
shield onto the
nozzle retaining
cap
Tool: 104119