Full Outdoor 2+0 XPIC IP Link
Page 18 of 39
Version
1.0
4.4.2
Alarm Conf
On this page you can enable which alarms will be reported back to the user as device status and SNMP
traps (if configured). Only such alarms which are enabled in this section will be recorded in the unit’s
Status
section. The configurable parameters have an appropriate editable field. Alarms can be configured only for
the local side but the actual status of both local and remote device is shown if available:
•
OK status
•
WARNING status
•
ALARM status
The section is divided into two parts:
ALARMS CONFIG
In this section are listed possible events with direct immediate impact on the link operability:
•
Modem License – This alarm will be raised when the license file is about to expire or is expired al-
ready or contains an invalid data
•
Modem HW – A hardware problem with the device such as non working ventilator
•
Modem SW – A software problem such as incompatible mode selection on local and remote side
•
Modem Sync - This alarm indicates actual status of modem synchronization
•
Modem Mux Sync - This alarm indicates actual status of packet processor (PBPS) synchronization.
•
Radio Telemetry – The status of communication with the radio part
•
Radio HW – The status as reported by the radio part
WARNINGS CONFIG
In this section are listed possible events with partial immediate impact on the link:
•
Modem Temperature – The temperature of the modem part
•
Modem LAN1/2 Link – status of the LAN port Link
•
Modem SFP1/2 Link - status of the SFP port Link
•
Modem Aggr/Prot – Status of the Aggregation/Protection
•
Modem MSE Level – Link quality indicator threshold settings and status
•
Modem FER – The threshold for error frames per minute
•
Radio Temperature - The temperature of the radio part
•
Radio RX Level - The receiving level threshold
•
Radio TX Mute – Transmitting Mute status
www.hypercable.fr www.e-rake.fr