6
Operation and maintenance manual, Discfilter HSF2200-1/2F PFC
2. SAFETY INSTRUCTIONS
Hydrotech Discfilters in the HSF2200 series are designed for safe operation provided that they
are installed correctly and used in accordance with the enclosed instructions. The equipment
must be installed correctly and adapted in accordance with local regulations. This equipment is
designed for use by one or more operators. You must read the relevant sections of this manual
before using the equipment or carrying out maintenance work.
⊲
Pay attention to all warning symbols that appear in this manual. If this information is ignored
it may result in serious personal injury and/or damage to equipment.
⊲
Assume all electrical equipment to be live.
⊲
Assume all hoses and pipes to be pressurised.
⊲
Before carrying out maintenance work, the main power switch (see Figure 2.3) must be turned
to the OFF (0) position and locked with a padlock.
⊲
Maintenance and service may only be performed by authorised personnel.
⊲
Adequate lighting should be used when operating the filter and when working in close prox-
imity to the filter.
2.1 Warning symbols
Warning symbols are used in this manual to draw attention to potentially dangerous situations:
Information that warns you of a potential risk of personal injury and/or damage to equipment.
Warning stickers (see Figure 2.1) are affixed to the filter to warn personnel and act as reminders
to keep hands and fingers away from the filter’s moving parts.
2.2 CE marking
This equipment is CE marked (see Figure 2.2), which guarantees that the equipment is designed,
manufactured and described in accordance with the requirements set out in the EU Machinery
Directive.
2.3 Conversion
The CE marking does not extend to any components that are not approved by Hydrotech AB and
that are used in conversion/reconstruction of the equipment. The warning symbols and CE mar-
king must be attached in such a way that they are fully visible. If any part of the equipment with
a warning symbol is replaced, a new symbol must be attached in the same position. Damaged
symbols and CE markings must be replaced immediately.
Figure 1
Figure 2.1
Figure 2.2
