HydroQuip PLATINUM PS-9003, Руководство по установке и эксплуатации

Страница: 11 / 24

9
Temp Sensor Mounting
Refer to the photos above. When installing the supplied temperature sensor drywell in the
wall of the tub, find a location as low as possible and close to a suction fitting. Try to stay
away from fittings returning water back to the tub. Drill a 1-3/16” hole from inside the tub
(1-2), install the supplied gasket onto the drywell and insert into the hole from inside the
tub (3-4), install the fastening nut from outside the tub shell and tighten 1/4 turn past hand
tight (5), and install the temperature sensor into the drywell (6).
1 2 3 4 5 6
A 5/16” drywell (sold separately) can be installed
in the plumbing if necessary. Select an area that
is located within the suction lines between the
body of water and the filtration pump for the most
accurate temperature readings.
GFCI
* This device may be installed in the control box or at the electrical service panel.
The GFCI is a mandatory electrical safety device required for all portable spas and hot tubs
as specified in the National Electrical Code Article 680. The GFCI is designed to provide
protection against potential electrical shock hazard should ground fault occur.
The installation of a properly sized Ground Circuit and Bonding Circuit is still required as
detailed in the Installation Manual. The GFCI in your particular installation may be installed
at the electrical service panel, a separate sub-panel or built into your Hydro-Quip spa
control system.
Systems with a built-in GFCI meeting the code requirements
will be marked on the top of the control panel with
identification label.
It is necessary to test the GFCI before each use and at least
monthly when the spa or hot tub is not being used regularly.
Test the device in the following manner:
With the power on, push the "TEST" button; there should
be an audible "click", which will disconnect the power to the
system. The "RESET" button will pop out slightly.
CAUTION - If the GFCI fails to operate in this manner, do
not use the spa until a qualified technician has corrected
the problem.
! To restore power, press the red "RESET" button in.