HydroQuip PLATINUM PS-9003, Руководство по установке и эксплуатации

Страница: 14 / 24

12
Mode Selection
The System Timer operates in one of two modes. Select the mode that best suites your
needs.
PROGRAM MODE 1 - The system timer
will activate the low speed of the jet
pump, filtering the water while the pump
is running. The water will be heated
according to the thermostat setting only
while the timer is on. While the timer is off
heating and filtration will not occur.
PROGRAM MODE 2 - Operation is the
same as PROGRAM MODE 1 except
that while the timer is off, the thermostat
will maintain the water temperature by
automatically cycling the pump and heater
on as needed.
System Timer (Setting Filtration)
The system timer provides the most efficient
and reliable method to filter and heat your
spa by activating the low speed of the jet
pump during user selectable time periods.
Each tripper represents 15 minutes.
Setting the Time
Carefully rotate the minute hand clockwise
until the appropriate time setting is
achieved. Be sure the set point is correctly
indexed to reflect AM/PM.
WARNING - Do not set time by rotating
outer dial. Do not rotate minute hand counterclockwise.
Set the operating times to provide filtration and/or heating for the number of hours per
day recommended by your spa manufacturer. We recommend at least two daily operating
periods of not less than 1 hour each and spaced no more than 12 hours apart.
Heavy usage of your spa may require longer periods to maintain water clarity and/or heat.
Be sure to set your system timer accordingly.
If you happen to live in an area subject to extreme cold weather conditions, your dealer
may recommend that you operate your spa on low speed continuously. This can be
accomplished simply by setting all of the trippers to the "On" position.
We recommend leaving your spa set to PROGRAM MODE 1(see page 15-16) for the most
energy conservative operation. This mode will allow you to set operating periods during
nonsleeping hours or during low cost energy periods.
We recommend PROGRAM MODE 2 (see page 15-16) for initial heating of your spa and if
you wish the spa to be ready for your enjoyment at any time of the day.
You do not need to change or override the timers to utilize the jet or blower modes.
Timers control only the low speed heat mode.