Hydromatic FG-100A-1, Руководство пользователя

Страница: 10 / 32

Installation 10
Charging
Battery status
Pump status
AC power
Silenced audible alarm
System Alert
= Excessi v e b attery drain; Stop p u mp, allo w b attery to charge (AC m u st b e on)
= Battery w ill not take a charge***; Replace b attery w ith a ne w 12 V lead-acid b attery
= Charge time monitor – 1; Check b attery for damage to cells; replace b attery
= Re v ersed b attery connections; C to + and – to –.*
= W rong b attery v oltage; Replace b attery w ith a ne w 12 V lead-acid b attery
= Charge time monitor – 2; Check b attery for damage to cells; replace b attery
= Failed pre- qu alification test – 2**; Replace b attery w ith a ne w 12 V lead-acid b attery
= Failed pre- qu alification test – 1**; Replace b attery w ith a ne w 12 V lead-acid b attery
LED Error Code Display
Condition Action
Error Condition and Corrective Action
NOTE: W hen the ‘System Alert’ LED is flashing,
look for one of the follo w ing error conditions.
* NOTE: If yo u r AC po w er is off and the u nit is dead (no LEDs lighted, no a u di b le alarm, p u mp isn’t r u nning),
check for re v ersed b attery connections to the charger/controller.
** Charger w as charging at a v ery lo w le v el to try to b ring a dead b attery b ack to life, bu t the b attery took too long
to charge. Try resetting the charger once or t w ice (p u sh the ‘System Test’ and ‘Silence Alarm’ bu ttons at the same
time to reset the charger).
*** Thermal R u na w ay condition
LED is Flashing (Slo w )
=
LED is OFF LED is O N Contin u o u sly
= =
5766 010 8
= Battery Charge is Belo w 20%; P u mp w ill sh u t do w n, b attery is not charging. Replace
b attery.
LED is Flashing (Fast)
=
TABLE IV – Error Code Displays (LEDs Flashing)
VERTICAL PUMPING DISTANCE - MODEL FG100-A1
8 FEET (2.4 M) 10 FEET (3.0 M) 12 FEET (3.7 M) 16 FEET (4.9 M)
Gallons Per Hour 1,440 1,200 840 No Flow at this Height
Aproximate Hrs Available 10 11.5 13 –
Total Gallons Pumped 8,500 7,000 5,000 –
TABLE VI – Capacity Ratings with a 100 A-H Deep Cycle Marine Battery
* These flow rates were obtained with a constant 12.7 VDC battery source. The actual GPH will vary due to a reduction in
output voltage from the battery as it discharges.
Control Button: Result of Pushing Button:
System Test Pump starts and all LEDs light up.
Will reset the ‘Pump Status’ LED.
When pushed with the ‘Silence Alarm’ button, the Charger/Controller
microprocessor resets and error code resets.
Silence Alarm Toggle; Prevents the audible alarm sounding. Press and release to reset.
Flood Light Toggles the flood light on the Charger/Controller on and off.
TABLE V – Control Button Functions