5
STEP 3 – CONFIRM LINK
If the communication light is displayed on the control, the
transmitter is linked properly.
If the light is not on, the devices will need to be linked.
To link the
transmitter and receiver, remove the cover on the
transmitter so that the button below the battery terminals
can be accessed. Press and hold both the button on the
transmitter and the button on the receiver simultaneously for
5 seconds and release. Upon release, the linkup process will
begin; the communication LED on the
receiver will flash
8 times. Linking is successful when the communication LED is
steady on.
The link button on the
receiver can also be used as a reset. If pushed, the receiver
will revert to a power-up condition; a temperature of 75°F (24°C) will be reported until
the first transmission is received (up to 10 minutes).
Communication
Power
Low Battery
Link
Wireless Outdoor Sensor 087
Receiver
Communication
Power
Low Battery
Link
Wireless Outdoor Sensor 087
Receiver
STEP 4 – INSTALL TRANSMITTER
The
transmitter should be mounted on a northern exterior wall
away from direct sunlight. In order to prevent heat transmitted
through the wall from affecting the sensor reading, it may be
necessary to install an insulating barrier behind the enclosure.
• The OS-200 should not be exposed to heat sources such as
ventilation or window openings.
• The OS-200 should be installed at an elevation above the
ground that will prevent accidental damage or tampering.
• Do not install the
transmitter on a conductive surface.
• The
transmitter will send outdoor temperature data every
10 minutes.
