Configuring the SMU
SensorMonitoring Unit - SMU
en(us)
Page 53 / 100
BeWa SMU1200 3854281 V2.0x en(us) 2013-08-20
2013-08-20
ADRESS – Setting HSI bus address / TCP/IP address
Under ADRESS set the HSI bus address and / or the IP address of the SMU.
There are 26 bus addresses from A - Z available for the HSI bus address.
Please note that each address can occur only once on any bus.
Use the following buttons to
set the address:
To change digit
To change the
value
o.k.
To confirm the
change
Esc
Cancel and
back
ADRESS
Description
HSI
Setting HSI bus address
IpADR
Setting up IP address
IpMASK
Setting IP subnet mask
IpGATE
Setting IP standard gateway
Press the
o.k.
to change to a sub-menu.
After you have changed the IP settings the SMU requires a restart. The
following appears on the display:
Restart the SMU to adopt the changed settings. To do this, remove the
power supply to the SMU for approx. 10 seconds.
