Hy-Brid Lifts
Maintenance & Troubleshooting Manual
HB-P827 / HB-P1027
Part No. SUPO 670
Rev. C
22
6.2 | Pre-start Inspection Checklist
This checklist must be used at the beginning of each shift or after every six to eight hours of use.
Failure to do so could affect the safety of the operator.
MODEL NUMBER: SERIAL NUMBER:
Keep inspection records up-to-date.
Record and report all discrepancies to your supervisor.
A dirty machine cannot be properly inspected.
Y — Yes/Acceptable N — No/Unacceptable R — Repaired
Description
Y N
R
Visual Inspections
Check that there are no damaged, dented, or bent structural members.
□ □ □
There are no loose or missing parts.
□ □ □
Check that warning and instructional labels are legible and secure. Ensure that load capacity is clearly
marked.
□ □ □
Check the platform rails and safety gate for damage.
□ □ □
Platform and base controls are not missing, damaged, or disconnected.
□ □ □
Electrical cables and wires are not torn, frayed, or disconnected.
□ □ □
Hydraulic hoses are not torn or loose, and there are no leaks. Check that hoses and cables have no
worn areas or chafing.
□ □ □
Check the tires for damage.
□ □ □
Check that all snap rings are secure in grooves on pivot pins.
□ □ □
Functional Tests
Gate closes automatically and latches (alignment can be adjusted with screw-on toe board or rail-
ing).
□ □ □
Platform Controls — Check all switches and push buttons for proper operation:
Emergency Stop (stops all movement)
Up/Down Controls (Elevates, Lowers, Enable button must be pressed)
□
□
□
□
□
□
Base Controls — Check all switches and push buttons for proper operation:
Emergency Stop (stops all movement)
Key Switch (Selects Platform Control, Ground Control, or Off)
Alarm (Not damaged, sounds for descent)
Up/Down Rocker Switch (Elevates, Lowers)
□
□
□
□
□
□
□
□
□
□
□
□
Wheels: Front and rear wheels rotate freely.
□ □ □
Brakes engage and hold when platform is elevated.
□ □ □
DATE
INSPECTED BY
WARNING
SECTION 6 | MAINTENANCE
