Damocles2
Damocles2
Damocles2
30
31
General Setup
Network settings of the device: Network parameters, trusted IP address range, temperature
units, output states, etc.
Device name
•
Name
– assigned to a particular device. This name is shown in all overviews along with the IP
address (UDP Config); it is used as the sysname variable in SNMP.
Network Settings
This block configures the main network parameters for Ethernet communication:
•
IP address
– IP address of the unit. After a change, the device needs to be restarted.
•
Submask
– Local network mask. After a change, the device needs to be restarted.
•
Gateway
– Default gateway. After a change, the device needs to be restarted.
•
Primary DNS/Secondary DNS
– Primary and secondary DNS server settings. Gateway needs to
be set correctly for correct operation.
•
HTTP port
– Port for communication using the HTTP protocol. Default is
80
.
•
HTTPS port
– Port for communication over the HTTPS protocol. Default is
443
.
•
TCP Telnet Setup
– Port for the terminal telnet setup mode. Default is
99
.
•
DHCP Client
– Activates automatic network configuration using a DHCP server. Enabled by default.
A DNS server is necessary for converting domain names to IP addresses.
Without a correctly configured DNS server, the following functions will not work:
• Time sync (SNTP), used in e-mails and SNMP traps to timestamp events
• E-mailing (SMTP)
• Logging of values with timestamps
IPV6
This block groups options for operation in networks that support IPv6.
•
Enable IPV6
– Enables IPv6 support.
•
Autoconfig IP parameters
– Enables automatic network configuration using SLAAC.
•
Link Local Address
– Link address of the device – only visible from the local network.
•
IP Address / Prefix length
– Global (public) IP address and network prefix. Consists of the link
address and the network prefix.
•
Gateway
– Default gateway. After a change, the device needs to be restarted.
•
Primary DNS/Secondary DNS
– Primary and secondary DNS server settings. Gateway needs to
be set correctly for correct operation.
Other Settings and Information
•
Syslog IP Address
– Syslog server address – only for HW group debugging purposes.
•
HW Security Protection
– A DIP switch that prevents any changes in the device configuration.
•
Outputs:
Values of outputs can be changed.
•
Configuration:
No changes are permitted.
The protection status is displayed in the bottom left-hand corner. When the HW Protection is
active, any configuration changes, including changes of the output states, are ignored. This
mode is useful when connecting Damocles2 to a publicly accessible network.
Note:
Any changes must be confirmed by clicking the Apply Changes button. A successful change is
indicated by an animation in the status bar next to the Apply changes button.
Counters
Resets the counter states at all device inputs – see Inputs. Resetting the device also resets
the coutners.
Web interface
Web interface
Содержание Damocles2 1208
Страница 1: ...Damocles2 User manual...
