Huvema CRDM 3050 x 16/1, Руководство по эксплуатации

Страница: 8 / 66

8
grounding wire is reliable, phase sequence of power supply is right, emergency
stop pushbutton is reliable.
1.2.26 Must clamp workpiece and cutter securely, but excessively cut workpiece.
1.2.27 Must clamp the arm, column, headstock securely, otherwise will result in
injury.
1.2.28 Select revolving speed and feed on the table of plate according to the
machining material and different diameter of drill, otherwise may cause injury to
the machine.
1.2.29 The spindle feed handle will turn when the spindle is automatically feeding,
and keep away from the handle, otherwise may cause injury to operator.
1.2.30 Keep others away from the work area during the run of machine.
1.2.31 Carefully observe things around the machine before turning the arm,
otherwise will result in serious injury.
1.2.32 There are push points between the headstock and stop block, the arm and
column, so operators will look to their own safety.
1.2.33 Shut off main supply before repairing the machine.
1.2.34 Shut off power supply of machine before eliminating the malfunction,
1.2.35 Must push the E-stop button on headstock panel in Figure 3.1 when the
machine has a fault, then shut off main switch on the door in Figure 4.4. Do not
switch on main switch before eliminating the malfunction.
1.2.36 The operation, maintenance and reparation of the machine must be done by
qualified person who have been trained to have the ability to forecast the potential
risks. Put the long hair into a safety hat during operation no matter the operator is
a man or a woman.
1.2.37 Operator must be familiar with the position of E-stop switch and working
method.
1.2.38 Electrical maintenance personnel work as working rules and wear insulated
shoes. Do not switch on main switch during the reparation, and hang electrical
warning plate on the power switch.
1.2.39 Appointed person is in charge of the key to electrical door and power
switch.