Huvema CRDM 3050 x 16/1, Руководство по эксплуатации

Страница: 7 / 66

7
1.2.10 Use tools properly. Don't force a tool or an attachment to do work which
was not designed. Sharp tools should be used. Deformed or dull tools should not
be used.
1.2.11 Make certain the motor switch is in OFF position before connecting the
machine with power supply.
1.2.12 Never attempt to operate or adjust the machine when the procedure is not
understood.
1.2.13 be careful, the handle of the spindle quill rapidly rebound.
1.2.14 It is advised that the operator should change machining position on
the table frequently in order to prolong the life of the machine.
1.2.15 Lubricate the machine in time according to the lubricating demand.
1.2.16 Keep the electrical elements clean, do not clean the electrical elements
with kerosene or gas.
1.2.17 Be sure that the spindle rotation of the machine comes to rest before
changing spindle speed.
1.2.18 It is forbidden to process flammable and explosive metal, for example :
pure aluminum, magnesium and so on.
1.2.19 The machine should never be used in flammable, explosive or humid
environment
1.2.20 The machine should be disassembled and assembled supported by the
lifting mechanism with sufficient bearing capacity.
1.2.21 Always stop the machine before adjusting the position of the cooling
nozzle.
1.2.22 Make sure that the operating site should kept well ventilated. It is
recommended that ventilation equipment should be provided on the operating site.
1.2.23 Must use the special swinging rings, bolts that manufacturer supplied to
swing the machine according to the swing figure.
1.2.24 Must make sure the each clamp part of the machine be in the clamp state
and adjust the machine well according to the demand.of swing.figure, then may
swing the machine.
1.2.25 Must check whether every clamp part is reliable, every travel is reliable,