Huvema CRDM 3050 x 16/1, Руководство по эксплуатации

Страница: 37 / 66

37
and after turning the handle 1-8 to the position in the picture, turning the dial to
the needed cutting depth, and aline with “0” of box size, and then turn handle 1-8
to the position in the fig.4.3, adjusting slightly until aline with “0”, and clamp
handle 1-8 using clamp knob on the other end, push handle 1-7, switch on feed
switch, when cutting depth reaches preset stroke value
，
handle 1-15 is put up
automatically and complete cutting.
4.8 Operated procedure of stopping the machine
：
4.8.1 Put up automatic feed handle 1-15, disconnect automatic feed.
4.8.2 Push moving handle 1-9 of the spindle, disconnect automatic feed.
4.8.3 Clamp headstock and column.
4.8.4 Stop the running of main motor by pushing the button.
4.8.5 Turn off the coolant switch.
4.8.6 Turn off the switch of the main power supply.
ATTENTION
：
1. When drilling to the critical state of demand size
，
feed capacity must be
minished to avoid destroying the tool.
2. If operating wrongly, the worker must push the red emergency-stop button (1-1)
on the plate of the headstock at once.