HUSTLER FasTrak 926501, Руководство пользователя, Страница: 7 / 32

3-1
OPERATION
Figure 3-1
IMPORTANT:
When access is required under the seat platform and
the seat is equipped with the optional arm rests, make certain to place
the control arms in the park brake position and pivot the arm rests
upward before placing the seat platform in the full forward position to
prevent arm rest damage.
Controls
For general location of the controls described in this section, refer
to Figure 3-1.
1. Ignition switch (Fig. 3-2) – a three position switch: off, run, and
start. With key inserted, rotate it clockwise to START position;
release key when engine starts, and switch will automatically return
to the RUN position.
2. Throttle control (Fig. 3-2) — a cable is linked to engine throttle for
controlling engine speed. Move lever forward to increase engine
rpm, move lever rearward to decrease engine rpm.
3. Choke control (Fig. 3-2) – a cable is linked to manually operate the
engine choke. When the lever is in the down position, the choke is
in the off (run) position. When the lever is pulled up, the choke is in
the on (start) position.
Do not operate the machine in the on (start)
position.
4. Control levers (Fig. 3-3 & 3-4) — these levers control the tractor’s
speed, direction, neutral lock, and park brake. Levers are used to
steer, accelerate, decelerate and change direction. When the control
levers are in the park brake position the tractor will not move when
the engine is on and drive pumps are operating.
WARNING: The parking brake may not hold the tractor if
parked on a slope. Block or chock the machine when parked on a
slope
5. Deck clutch switch (Fig. 3-2) — this switch engages the deck. Pull
the switch up to engage and push switch down to disengage the
clutch.
IMPORTANT: Never engage clutch with engine running at high
rpm or when the deck is under load. Clutch, belts or deck could be
damaged.
6. Deck lift pedal (Fig. 3-5) — the deck lift pedal is used to raise or
lower the deck. Push on the pedal to raise the deck and then place
the deck height locking pin into the desired cutting height hole.
Push the deck lift pedal to raise the deck when going over
obstructions.
Figure 3-2
Figure 3-3
1. Ignition Switch 5. Deck lift pedal 9. Deck adjusting rod 14. Deck height indicator
2. Throttle lever 6. Oil Pressure light 10. Anti-scalp wheels 15. Park brake switch
3. Control levers 7. Fuel tanks 11. Discharge chute 16. Choke lever
4. Deck clutch switch 8. Battery 12. Left deck cover
13. Right deck cover
IIg gn niittiio on n
s sw wiittc ch h
T Th hrro ottttlle e
Deck clutch switch
Control
lever
FasTrak Controls
9
1
7
12
4 2
11
13
10
5
6
8
14
7
9
10
3
10
10
O Oiill p prre es ss su urre e lliig gh htt
15
15
Choke
16
Shown with control levers
in park brake position
365270 Rev. 9/03