HUSTLER FasTrak 926501, Руководство пользователя, Страница: 13 / 32

WARNING:
Avoid skin and clothing contact with battery acid.
Always wear eye protection when checking the battery, acid can
cause serious injury to skin and eyes. If contact occurs, flush area
with clean water and call physician immediately. Acid will also
damage clothing.
Do not drink the battery electrolyte.
Do not allow open flame near the battery when charging.
Hydrogen gas forms inside the battery. This gas is both toxic and
flammable and may cause an explosion if exposed to flame.
Always remove the negative ground first and replace it last.
Do not overfill battery.
Electrolyte may overflow and damage paint, wiring or structure.
When cleaning the battery, use soap and water. Be careful not to
get soap and water into the battery. Clean the battery terminals
with a solution of four parts water and one part baking soda when
they become corroded.
WARNING: Shorts caused by battery terminals or metal tools
touching metal tractor components can cause sparks. Sparks can
cause a battery gas explosion which will result in personal injury.
Prevent the battery terminals from touching any metal tractor
parts when removing or installing the battery.
Do not allow metal tools to short between the battery terminals
and metal tractor parts.
WARNING:
Incorrect battery cable routing could cause damage
to the tractor and battery cables. This can cause sparks which can
cause a battery gas explosion which will result in personal injury.
Always
disconnect the negative (black) battery cable before
disconnecting the positive (red) cable.
Always
connect the positive (red) battery cable before connecting
the negative (black) cable.
Common circuit failures are usually caused by shorting, corroded or dirty
terminals; loose connections, defective wire insulation or broken wires.
Switches, solenoids and ignition components may also fail, causing a
shorted or open circuit.
The electrical system is protected by fuses located on the right fuel tank
instrument panel. Fig. 4-3 The fuses are as follows:
Main - 20 amp, blade-type
Clutch/Aux - 10 amp, blade-type
Before attempting any failure diagnosis of the electrical system, use a
test light or voltmeter to check the battery voltage. If the battery voltage is
satisfactory, check the cleanliness and tightness of the terminals and ground
connections. A general understanding of electrical servicing and use of
basic test equipment is necessary for troubleshooting and repair.
Major overhaul or repair of the starting motor or charging system
should be performed by trained technicians only.
Access to integrated pump/motor units
The integrated pump/motor units are accessed by lifting the seat
platform. The seat platform is hinged at the front. To raise it, remove the
two cap screws and tilt seat platform up and forward. (Fig. 4-4)
If the seat is equipped with the optional arm rest kit, make certain
to place the control arms in the park brake position and pivot the arm
rests upward before placing the seat platform in the full forward
position to prevent damage to the arm rests.
Hydraulic system
The Hustler FasTrak is equipped with two Hydro-Gear C-IZT
integrated pump/motor transmissions. Fig. 4-5
Units built prior to serial number 03037002 are sealed for life and do
not require scheduled service.
Units starting with serial number 03037002 and later have a
replaceable filter which will require replacement every 200 hours or 2 years
whichever comes first. The required service involves draining the oil and
installing a new filter kit (Hustler p/n 789511). Fill with new 20W50
engine oil.
4-3
Figure 4-2
Battery
365270 Rev. 9/03
Figure 4-3
F Fu us se e
Figure 4-4
C Ca ap p s sc crre ew ws s
Figure 4-5
C-IZT integrated
pump/motor