HUSTLER FasTrak 926501, Руководство пользователя, Страница: 20 / 32

Keep oil and grease away from belts, and never use belt dressings. Any
of these will destroy the belt composition in a very short time.
Deck belt replacement
1. Park the unit on a flat surface. Stop the engine and remove the
ignition key. Make sure deck clutch switch is
in the down (OFF)
position. Place control levers in the park brake position.
Disconnect negative battery cable.
2. Place the deck in the lowest position.
3. Remove the deck belt covers.
4. Release the deck belt tension by pulling on the belt tension chain and
sliding the chain out of the anchor bracket slot. This will relieve the
tension on the deck belt idler spring. Fig. 4-17
5. Pull the idler to the left of the machine to provide maximum belt
clearance.
6. Remove the existing belt and replace with a new belt.
7. Route the new belt per Fig. 4-17.
8. Re-tension the deck belt idler per the Deck drive belt adjustment
section on page 5-4.
9. Re-install the deck belt covers.
10. Re-attach the negative battery cable.
Integrated pump/motor drive belt replacement
1. Park the unit on a flat surface. Stop the engine and remove the
ignition key. Make sure deck clutch switch is
in the down (OFF)
position. Place control levers in the park brake position.
Disconnect negative battery cable.
2. Place the deck in the lowest position.
3. The deck belt must be removed from the clutch pulley first by
releasing the deck belt tension by pulling on the belt tension chain
and sliding the chain out of the anchor bracket slot. This will relieve
the tension on the deck belt idler spring. Fig. 4-18
4. Remove the deck drive belt from the electric clutch pulley. This belt
does not need to be removed from any of the other pulleys.
5. Release the tension from the integrated pump/motor belt by pulling
on the idler pulley (extending spring carefully) and sliding the belt
over it. Use caution when releasing the idler pulley as there is still
tension on it and it will snap back into position. Fig. 4-18
6. Slide the belt off the engine pulley. The belt will have to be slid
above the engine pulley to allow the belt to be removed from the
other pulleys. Fig. 4-19
7. Slide the belt over the integrated pump/motor pulleys.
8. Slide the belt off of the fixed idler pulley.
9. The belt can now be removed from above the engine pulley.
4-10 365270 Rev. 9/03
Figure 4-18
1
3
2, 6
4
5
1. Pump belt
2. Engine pulley
3. Pump idler pulley
4. Pump idler arm
5. Pump pulley
6. Electric deck clutch
7. Pump idler spring
8. Fixed idler pulley
7
Viewed from
top of unit
5
8
Figure 4-17
1
Deck Belt Drive Layout
1. Spindle drive belt
2. Deck blade spindle pulley
3. Spindle belt tension idler
4. Spindle belt tension idler spring
(7.5" at operation)
5. Deck belt idler pulley
6. Idler arm
2
2
5
4
5
3
2
6
Figure 4-16B
Figure 4-16A
Engine oil
drain plug
Engine oil filter
Engine oil
filler tube
Dipstick
Engine
oil filter
Dipstick &
Engine oil
filler tube
Engine oil
drain plug
Briggs & Stratton
Honda