HUSTLER FasTrak 926501, Руководство пользователя, Страница: 27 / 32

365270 Rev. 9/03
27. Compress the deck lift assist springs so that there is 1” of space
between the front nut on the spring and the rear nut on the deck lift
block (Fig. 5-18). Typical both sides.
28. When completed, all chains will be tight, and deck cutting height
will be set to the deck height indicator.
Deck cutting height adjustment
Deck height is adjustable from 1” to 4” (2.54 cm - 10.16 cm) in 1/4”
increments. The holes in the height adjusting bar are spaced at 1/2”
intervals. By turning the height adjusting stop around, 1/4” increments can
be attained due to the 1/4” plate that is part of the stop. Fig. 5-19
EXAMPLE:
When the height adjusting stop is placed in the 1-1/2”
hole, with the 1/4” plate facing to the front of the unit, the cutting height
is at 1-1/2”. When the height adjusting stop is placed in the 1-1/2” hole,
with the 1/4” plate on the operator’s side of the hole, the cutting height is
at 1-3/4”.
When the height adjusting stop is placed in one of the holes, with the
1/4” plate on the operator’s side of the hole, the deck height will be set at
one of the following: 1-1/4”, 1-3/4”, 2-1/4”, 2-3/4”, 3-1/4”, or 3-3/4”.
When the height adjusting stop is placed in one of the holes, with the
1/4” plate facing to the front of the unit, the deck height will be set at one of
the following: 1”, 1-1/2”, 2”, 2-1/2”, 3”, 3-1/2”, or 4”.
The notch located at the rear of the right height adjusting bar (4” height)
is to be used when the deck is placed in the transport mode.
Anti-scalp wheels
Anti-scalp wheel kits are standard on the FasTrak. These anti-scalp
wheels are designed to minimize scalping when mowing on rough uneven
terrain.
After setting the cutting height, adjust the front anti-scalp wheels so they
extend below the deck but do not contact the ground. They should always
be at least 1/4” to 3/4” (.6 cm to 1.9 cm) below the deck. With the unit
sitting on a flat level surface, the front wheel position can be adjusted up or
down as needed from 3/4” to 1-3/4” (1.9 cm to 9.5 cm) below the blade
surface. Move the front wheels up or down, in 1/2” (1.3 cm) increments,
using the different axle mount holes in the wheel mount bracket. Fig. 5-20
When adjusting the rear anti-scalp wheels, the wheel should be in the
lower axle mount hole when the front anti-scalp wheels are in the lower or
middle axle mount holes. When the front wheels are in the upper axle
mount hole, the rear wheels should be in the upper axle mount hole as well.
NOTE: When the anti-scalp wheels are installed, the minimum cutting
height is 1-1/2” (3.81 cm) with the anti-scalp wheels set at 3/4”.
5-5
Figure 5-17
Foot
pedal
Nuts
Figure 5-18
L Liifftt b bllo oc ck k
1”
Deck lift rod
1”
Deck lift
assist springs
Figure 5-20
Adjusting
holes
Anti-scalp
wheel
Figure 5-19
Height
adjusting
stop
Stop
handle
365270 Rev. 9/03