Medium Temperature
P/N 0378414G
1-7
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
OFFSETTING BUMPERS AND TOP RAIL
Offsetting the bumpers and top rails helps to
disguise the joint locations, giving the lineup a
smoother look.
1. Locate starter bumpers and top rail. They are
shipped with the left-end kit.
2. Remove factory installed top rails and
bumpers from cases as follows:
a. To remove top rails, push rail toward the
back of the case with one hand while lift-
ing the top edge off the light channel with
the other hand. See drawing below.
b. Starting at one end, carefully peel bottom
of top rail free of color panel and set the
rail inside the case.
c. Remove upper and lower bumpers by
pulling bumper away from bumper retain-
ers. Be careful not to lose the internal
joint trims on the upper bumpers.
3. Starting at the left end of the line up, install
the upper bumper starter section first. To
install,
a. Position internal
joint trims so that the
first is flush to the
left-end panel and
the second is cen-
tered between the
starter bumper and
the full length
bumper as shown
below.
b. Install full length bumpers and internal
trims offset across joints. Make sure that
no gaps exist between sections. Continue
installing the upper bumpers the length of
the line up. Do NOT install the last upper
bumper section at this time. This section
will be installed in the last step.
4. Install lower bumper starter and full length
lower bumpers by simply pushing them into
place. There are no internal joint trims on the
lower bumpers.
Pull
Step 2-b.
Upper
Bumper
Pull
Internal
Joint Trim
Push
Lift
Push
Step 2-a.
Step 2-c.
Retainer
Merchandiser
Joint
Full Length
Bumper
Starter
Bumper
Internal Joint Trims
