1-4
I
NSTALLATION
P/N 0378414G
JOINING INSTRUCTIONS
Sectional construction means that two or more
merchandisers may be joined in line yielding one
long continuous display requiring only one pair
of ends.
A
LL JOINTS MUST BE AIR
-
TIGHT TO PREVENT
FORMATION OF ICE OR CONDENSATION
.
Prep Case
1. Check to be sure that merchandisers are
level and that the factory-installed nut
retainers and alignment pins are in place.
Locate Joint Kit and check contents against
parts list.
2. Remove shelves (if installed), display racks,
pans, front shelf supports and front air
grilles from the right end.
3. Remove the rear panel(s) from the right end.
On multi-deck cases remove the lower back
panel first. To remove a panel lift it up from
its bottom edge and out. No tools are
required.
Apply Gaskets
1. Apply
1
/
2
in. (13 mm) gasket in the horizontal
recess across the bottom and up the front of
the merchandiser as shown. Gasket should
cover slots.
2. Apply the 1
5
/
8
in. (41 mm) gasket to cover
foam-to-metal gap at rear of case and across
the top as shown. Be sure to overlap gaskets
as shown. Check to be sure that there are no
gaps between gasket and merchandiser.
Fasten Cases
1. Move the second merchandiser into position
against the first. Match the alignment pins
with the corresponding holes.
2. Fasten fronts together using cap screws, flat
washers, lock washers and nuts. Tighten
only until front panels touch.
Do not tighten
fully.
3. Use the cap screws, flat washers and lock
washers provided in the joint kit to draw
the merchandisers together at rear.
Do not
tighten fully.
4. Draw canopies of multi-deck
wall merchandisers together
by inserting threaded rod
through top shoe as shown.
Fasten each end with washers
and nuts.
Tighten only until
canopies touch.
5. Tighten joints in the order
shown (A, B, C, D) until
gaskets are compressed, and
cases join smoothly.
A
B
C
PW & MWG
models
1
5
/
8
in. Gasket
(41 mm)
1
/
2
in. Gasket
(13 mm)
