INSTALLING D5RRIS
Overview
The coil package must be suspended above the
cooler wall opening from an adequate support
structure. It is imperative that both the method
and the materials used to suspend the coil pack-
age be of sufficient strength to support the coil
package.
These models are designed for use with roll-in
carts or free-standing (unattached) shelving.
DISCLAIMER: These methods of securing the
coil package are suggestions only. It is the
responsibility of the store designer, installer and
end user to ensure the store’s structural capacity.
Hussmann assumes no liability for consequences
resulting from failure of store structure or materi-
al used in installation.
Two 1
5
/
8
x 1
5
/
8
inch (41 x 41 mm) channel struts
are provided for hanging the coil package. These
struts extend the full length of the case and are
bolted to the case at the factory. Use
1
/
2
in. (12.7
mm) clamp nuts to secure the hanging rods to the
struts. Although these struts allow flexibility in
hanging rod location, the end support rods must
be within 12 in. (305 mm) of the coil package
end. For a 12 ft (3658 mm) coil package, the cen-
ter hanging rods must be within 12 in. (305 mm)
of the center of the case.
IMPACT Rear Roll-in
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
P/N 0435045A
1-3
Hanging Support Spacing
Case
Coil
Minimum Number of
Length
Package
1
/
2
in. dia.
(12.7 mm)
ft
(mm)
Weight
Threaded Drop
lb
(kg)
Rods Required
8
(2438)
485
(220)
4
12
(3658)
750
(340)
6
Cantilevered “
I
” Beam
Store Joist
Field Supplied
Suspending Rods
Channel Struts
Coil Package