Husqvarna FS7000 DL, Руководство оператора

Страница: 20 / 160

20 –
English
OPERATING
• When the blade is lowered the current cutting depth will be
showing the difference between the reference point and
the diamond blade.
• The saw will not lower to any depth greater than the stop
position set in the display. If a deeper cut is required, turn
the Blade depth knob to a new depth position. You can
also disengage the Blade depth stop by pushing the Blade
depth stop button to override the depth stop feature.
Straight line sawing
While cutting, the blade is creating resistance to driving force
from rear wheels which will cause the machine to yaw in the
same direction as the blade is mounted on. This effect can be
counteracted by adjusting the angle of the rear axle using E-
track or manual axle adjustments.
Saw with E-track
• On the control panel, push the E-track adjustment buttons
representing left and right rear axle adjustments. Press
several times for fine adjustments.
• By pressing the E-track zero button on the control panel
the rear axle will return to predefined center angle.
• Return to previous setting by once again pressing the E-
track zero button on the control panel.
• The E-track gauge on the display will indicate the present
angle of the rear axle. The change is saved both if the
ignition is switched off or if the machine is without power.
• Adjustments can be made both while sawing and not
sawing.
• Visually confirm the axle movement and direction.
To set new center angle for E-track
• Adjust the rear axle to the desired new center angle.
• In the display enter the Setup menu 2 and press calibrate
E-track button. This setting will be saved even after engine
restart.
Saws with manual axle adjustment
• The rear axle is adjusted by turning the adjustment bolt
located at the rear lower left of saw frame with an 18mm
wrench.
• If the saw steers to the right while sawing, turn the
adjustment bolt counterclockwise.
• If the saw steers to the left while sawing, turn the
adjustment bolt clockwise.
Transport and storage
• Remove the blade before transportation or storage of the
machine, to avoid damage to the blade.
• Remove all adjustment tools and wrenches
<1200 RPM
1
2
3
4
c
CURRENT: STOP:
0 4
cm cm
WORKING HOUR
V
8
10
12
16
14
V
100
40
60
80
120
c
8
10
12
16
14
V
100
40
60
80
120
c
<1200 RPM
1
2
3
4
c
CURRENT: STOP:
0 4
cm cm
WORKING HOUR
V
8
10
12
16
14
V
100
40
60
80
120
c
<1200 RPM
1
2
3
4
c
CURRENT: STOP:
0 4
cm cm
WORKING HOUR
V
!
WARNING! Remove the cutting blade prior to
lifting, loading, unloading or transporting
the machine.
8
10
12
16
14
V
100
40
60
80
120
c
<1200 RPM
1
2
3
4
c
CURRENT: STOP:
0 4
cm cm
WORKING HOUR
V
Setup Menu 2
Press MENU button
information Codes
Calibrate
1
to enter Setup Menu
Fault
E-track
System
Gearbox
and
Blade
info