16 –
English
OPERATING
Handle position
Use the handlebars to maneuver the saw.
The position of the handlebars can be adjusted in height and
length.
•
Loosen the locking knob
A
to adjust the length.
•
Turn handle adjustment locking knob
B
counterclockwise
to unlock and reposition handlebar. Turn clockwise to lock
handlebar in position. Set handle to most comfortable
working height. Tighten the locking knob.
Moving the machine
Prior to moving the machine, read and understand section
”Starting and stopping”.
Moving the machine with the engine off
•
Turn Engine start switch to the ignition on position.
•
Raise the saw by pressing up the Raise/lower switch on
the Speed control lever until the blade (if installed) clears
the pavement surface.
•
Put Speed control lever into the STOP position.
•
Set the Transmission bypass valve counterclockwise to
the up (neutral) position.
•
The saw can now be moved by standing behind it and
pushing (while holding the handlebars).
Moving the saw with the engine on
•
Turn Engine start switch to the ignition on position.
•
Raise the saw by pressing up the Raise/lower switch on
the Speed control lever until the blade (if installed) clears
the pavement surface.
•
Put Speed control lever into the STOP position.
•
The Engine throttle is at idle speed setting per default.
•
Ensure that the Blade clutch is disengaged (if clutch
installed).
•
While the Engine start switch is in the ignition on position,
check the display and ensure that preheat symbol is
turned off. If it is lit, the glow plugs warm the engine and
the engine will not start. Wait a few seconds until turned
off.
•
When preheat symbol is off, turn the Engine start switch
to the engines start position until the engine starts, then
release the switch. It will return to ignition on position
automatically.
CAUTION! Never use the handlebars to lift the saw.
!
WARNING! Do not attempt to push the saw
while it is in neutral position on a grade (or
hill). The saw operator could lose control of
the saw and cause injury to oneself or other
persons in the area.
A
B
!
CAUTION! Pay special attention on clutchless
machines, blade starts rotating at start. For
safety reason, do not move the saw sideways
or out of the cutting area with blade installed
and rotating.
NOTICE! If the engine does not start, turn Engine start
switch to STOP position and check the display for any
messages. If none, repeat above steps. Else, take measures
according to message in the display prior to new starting
attempt.
<1200 RPM
1
2
3
4
c
CURRENT:
STOP:
0
4
cm
cm
WORKING HOUR
V
8
10
12
16
14
V
100
40
60
80
120
c
1
2
Содержание FS7000 DL
Страница 159: ......
