Husqvarna AUTOMOWER EPOS, Руководство оператора

Страница: 47 / 68

Message Cause Action
No loop signal
The power supply or the low-voltage
cable is not connected.
Examine the LED status on the charg-
ing station. If there is no power to the
charging station, the LED is not lit. Ex-
amine the wall socket connection and if
a residual-current device is engaged.
Make sure that the low-voltage cable is
connected to the charging station.
The power supply or the low-voltage
cable is damaged.
Replace the power supply or low-volt-
age cable.
ECO mode is activated and the product
has attempted to start outside the
charging station.
Put the product in the charging station.
Start the product and close the hatch.
Refer to
Start on page 40.
The product does not find the loop sig-
nal from the charging station.
Put the product in the charging station
and generate a new loop signal. Refer
to New loop signal on page 37.
The charging station in not installed
correctly.
Install the charging station according to
the instruction. Refer to To install the
charging station on page 23.
Wrong PIN code An incorrect PIN code has been en-
tered. 5 tries are permitted, and the
product is then blocked for a period of
time.
Enter the correct PIN code. Contact
your local Husqvarna representative if
you forget the PIN code.
Outside work area The Virtual boundary is too close to the
edge of the work area.
Make sure that the Virtual boundary is
installed correctly. Refer to
To examine
where to put the Virtual boundary on
page 19.
The work area slopes too much by the
Virtual boundary.
The product finds it hard to distinguish
the signal from another product installa-
tion close by.
Put the product in the charging station
and generate a new loop signal. Refer
to New loop signal on page 37.
1460 - 002 - 06.04.2020 Troubleshooting - 47