Husqvarna Viking Viking Topaz 40, Руководство пользователя

Страница: 24 / 104

C
A
B
C
D
2:8
WINDING THE BOBBIN WITH
THE MACHINE THREADED
Make sure that the presser foot is up and the needle is in the
highest position.
Note! Do not use a plastic presser foot when bobbin winding.
1. Place an empty bobbin on the bobbin spindle on the top
of the machine. The bobbin only fits on one way, with
the logo facing up. Use only original HUSQVARNA
VIKING
®
bobbins.
2. Pull the thread from the needle under the presser foot and
to the right through the thread guide (C).
3. Guide the thread through the hole in the bobbin (D) from
the inside to the outside.
Note: When using an earlier version of HUSQVARNA VIKING
®
bobbins that do not have a hole, wind several turns of thread on the
bobbin to get started.
4. Push the bobbin winder spindle to the right to wind.
A pop-up appears on the screen to inform you that
bobbin winding is active. To adjust winding speed, use the
slider in the pop-up. Start bobbin winding by pressing the
foot control or touch the start/stop button.
When the bobbin is full, it will stop winding. Release the
foot control or touch the start/stop button to stop the
bobbin winder motor from running. Move the bobbin
winder spindle to the left and the pop-up will close.
Remove the bobbin and cut the thread using the bobbin
thread cutter.
Note: It is important that you cut the thread end close to the bobbin.
Note: Moving the bobbin spindle to the left will engage the sewing
mechanism. Always stop winding by pushing the Start/Stop button or
releasing the foot control before moving the bobbin spindle.
WINDING THE BOBBIN USING
THE VERTICAL SPOOL PIN
1. Place an empty bobbin on the bobbin spindle on the top
of the machine. The bobbin only fits on one way, with
the logo facing up. Use only original HUSQVARNA
VIKING
®
bobbins.
2. Place the large spool cap and a felt pad under the spool on
the main spool pin set in the vertical position.
3. Bring the thread over and behind the pre-tension thread
guide (A) and down around the thread tension disc (B),
then through thread guide (C) as illustrated.
4. See Winding the Bobbin with the Machine Threaded, step
3-4.