Huskie Tools HH100, Руководство по обслуживанию

Страница: 15 / 64

15
Table 4. Tightening Torque Requirements (Ft. lbs.)
HH100 HH150-2 HH300-2 HH500-2 HH750-2 HH1000-2
Side Rod NA 400 ±35 550 ±35 NA NA NA
Side Rod Back Nut NA NA NA 730 ±35 730 ±35 770 ±35
Front Cap Set Bolt 175 ±35 NA NA NA NA NA
Back Cap Set Bolt 175 ±35 NA NA NA NA NA
Bracket Bolt 150 ±35 260 ±35 260 ±35 260 ±35 260 ±35 400 ±35
GREASING REQUIREMENTS
The hammer should be greased each startup and after every 2-3 hours of operation. The
grease nipple is located at the front cap as shown in Figure 6. Approximately 10 shots in
the front cap are recommended when the tool is at the upper limit of travel.
Figure 6. Grease Fitting
Figure 6.
1 3
4
2
5
1
3
6 2
4
7
1 3 5
2 6
4
8
4
1
3
2 5
Figure 5. Tightening Sequence