Husar Winch BST 45000 Lbs, Инструкции по сборке и эксплуатации

Страница: 8 / 28

6
Keep all hoses away from any areas where heat may be considered too extreme such
as an exhaust manifold or turbo. Lines should not be allowed to rub on any abrasive
or vibrating surfaces. In some applications, 90°fittings on the directional valve and
motor or balance valve are necessary to make hose mounting more flexible. After
plumbing has been laid out on vehicle, install o-ring fittings supplied to valve. Torque
tight. Do not over tighten any fittings. Install o-ring fittings on Winch Motor. Torque
tight. Connect any hose port A on motor to port A on directional valve, port B on motor
to port B on directional valve, port P on directional
valve to pump’s high pressure port,
port T on valve to reservoir, if necessary connect any hose port S on valve to steering
box. Attach any o-ring or seal from vehicles original tube fitting to tube fitting.
Working hydraulic principle chart and installation illustration
（
YD
）
: