Husar Winch BST 45000 Lbs, Инструкции по сборке и эксплуатации

Страница: 12 / 28

10
Caution: Always leave at least five turns of cable on the drum; Review Winch Safety
Warnings and Precautions on page 2
、
3 before continuing.
3. Reengage the clutch by turn the clutch assembly to the
“CLUTCH IN” position, if
the clutch is not engaged, the winch drum must be turned by hand, until the clutch
is totally engaged.
4. Insert the switch assembly connector onto the directional valve
5. Test-run winch in two directions, each direction last one or two seconds, to test
whether winch working normally in two directions, meantime make sure the clutch
totally engaged.
6. While standing aside of the tow path, hold and operate the Switch Assembly
supplied by your choice. To reverse directions. Wait until the motor stops before
reversing directions.
7. When the towing is complete, remove the switch assembly. From the female
connector of the directional valve and replace the female connector cover.
Maintenances
eWINCH ACCESSORIES YOU WILL NEED
NOT INCLUDED WITH YOUR WINCH
Gloves
– For handling the wire rope and hook strap.
Anchor Strap/Chain
– Tree saver anchor straps are made of high quality nylon with
high tensile strengths up to 15000lbs.
Heavy Blanket
– place on the cable to absorb energy should the wire rope break.
RIGGING TECHNIQUES
Self-Recovery
Locate a suitable anchor such as a strong tree trunk or boulder.
Always use a sling as an anchor point. CAUTION Do not attach
the clevis hook back onto the cable as this could cause damage to
the cable.As shown in Fig 3.1
Fig 3.1