HURST ML-630-SI, Инструкция по эксплуатации

Страница: 23 / 48

23
9. Dismantling the equipment /
deactivation following operation
WARNING for power units with combustion engines!
Check that the engine switch is set to the “OFF“ position and remains there to
prevent the unwanted starting of the power unit!
Once the work has been completed, all connected equipment is to be reset to its neutral
position (storage position) before the unit is shut down. You can then switch off the engine
of the power unit.
Mono-couplings:
If the connected hose assemblies are to be dismantled during shut-down, decouple as
described in chapter "Coupling the mono-couplings". Ensure that you put the dust protection
caps back onto the mono-coupling halves.
Clean the hydraulic power unit of any stubborn dirt prior to storage.
If the equipment is to be stored for a longer period of time, the exterior is to be cleaned
completely and the mechanically mobile parts are to be lubricated. If storing a unit with
combustion engine, you should also remove the fuel from the fuel tank.
Avoid storing the hydraulic power units in a damp environment.
Observe the additional regulations in the separate operating instructions for the hoses.
CAUTION!
Depending on the size and weight of the hydraulic power unit it should be
transported to the storage location by one or more persons.