HURST ML-630-SI, Инструкция по эксплуатации

Страница: 18 / 48

18
7. Set-up and start-up
7.1 Set-up
7.2 Start-up
WARNING/CAUTION!
Because of possible spark formation, combustion engine units and electrical
equipment cannot be used in an explosion-risk area. Units with combustion
engines must not be used in enclosed spaces, as there is a danger of poisoning
and/or asphyxiation!
The unit is to be set up in a suitable location (secure location /
À
at surface / suf
¿
cient distance
from vehicles, loads, sources of ignition, etc.).
HURST units work perfectly at an angle of up to 20°. However, in order to guarantee maximum
safety and
À
uid withdrawal, they should be operated in as horizontal a position as possible.
ATTENTION!
Never mix up the fuel and hydraulic
À
uid tanks when
¿
lling the tank; this can
damage the power unit!
NOTE:
The engine oil level must be inspected before the
¿
rst commissioning or after
longer periods of storage. First
¿
ll the engine or top up the engine oil!
For safety reasons, HURST power units do not contain engine oil upon delivery!
7.2.1 First commissioning - Power unit without engine oil, hydraulic fl uid and gasoline.
1. Pour in the engine oil according to the instructions
in the scope of delivery included with the separate
manufacturer operating instructions regarding the
¿
ller
opening (engine oil
¿
ller cap, see chapter "Installation of
the power unit").
2. Pour hydraulic oil into the hydraulic
À
uid tank until the
¿
ll
level indicator in the viewing window is between MIN/
MAX (see illustration on the right). The upper mark
shows the absolute
¿
ll level when connecting additional
equipment with increased usable volume. The resulting
¿
ll quantity is up to 3.0 l.
3. Pour fuel (gasoline) into the tank until the
¿
ll level is just
below the
¿
ller opening. If the power unit is resting on
an inclined surface, do not
¿
ll the tank to its maximum
capacity.
Hydraulic oil
¿
ll level indicator