Version August 2010
6
EN
HWT 160–M User’s Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
•
Operate the machine only when it is connect to a power supply
source that is adequate for the power supply requirements posed
by the electrical facing tool and the electrical heating element.
2.3 Intended Use
The butt-welding machine was designed and manufactured for the jointing
of pipes and/or fittings made of thermoplastic material and of the dimen-
sions catered for by the machine components, applying the butt-welding
process with plasticization by a heating element.
Any other use or use in the intended way but for unintended materials is
deemed unintended use, and any such use will void any and all warranty
and liability assumed by the manufacturer for the product, including for
consequential damage.
3
Machine Description
3.1 Component Overview
3.2 Transport, Storage, Shipment
The machine ships on the operating frame and requires only to be fas-
tened in its working position using the applicable screws. The shipment
is properly wrapped and packaged to avoid possible damage.
Info
Immediately after receipt, make sure that the shipment is
complete and in a good condition and notify the transporter of
any defects or missing part. Complaints at a later point may no
longer be eligible for remedy.
3.3 Technical Specifi cations
HWT 160–M
Operating Range
Suitable Materials
Pwr Supply Heat. Element, Facing Tool
Carriage Stroke
40 (32) - 160 mm O.D.
PE, PP, other thermoplastics
230 V, 50/60 Hz
130 mm (5-1/8")
Heating Element
Facing Tool
Clamps
Force Indicator
Locking Bar
Hand Wheel for
Moving the Carriage
Facing Tool Front Support
(see detail below)
