HunterDouglas Silhouette Duolite Window Shadings PowerView Motorization, Установка Эксплуатация Уход

Страница: 27 / 36

OPERATION
25
Problem PowerView
®
only: The bottom rail does not raise or lower completely, or its
location when fully lowered has changed over time.
Solution The batteries may be low in the battery wand or satellite battery pack. Replace
the batteries.
Check that the battery wand, satellite battery pack, or 18V DC power supply
is securely connected to the power cables and the cables are not pinched or
caught in the headrail or installation brackets.
Check that there is clearance between the ends of the shading and the window
casement on inside mounts.
Check if the fabric rolls up evenly into the headrail. If not, see “Adjust the Bottom
Rail Weight of the Front Shading” on page 22.
Reset the upper and lower travel limits. See “Resetting the Shading
(If Necessary)” on page 19.
See the PowerView Motorization Remote Control Guide for operation or
programming troubleshooting solutions.
Problem
UltraGlide
®
only:
The tassel cord and lower cord connector have detached
from the upper cord connector.
Solution To Reattach the Tassel Cord:
■ ■
Hook one side of the lower cord connector to
the upper cord connector.
■ ■
Rotate the lower cord connector until it snaps
into place.
■ ■
Twirl the tassel cord to pull any stray
cord fibers out of the junction of the cord
connector halves. Stray fibers in the junction
may cause the connector to come apart.
Problem The front sheer fabric of the front shading clings to the rear sheer fabric .
Solution Lightly apply a static spray for home furnishings. Follow the manufacturer’s
directions. Allow the shading to dry in the fully lowered position. If necessary,
reapply the static spray each time the shading is professionally cleaned.
Upper Cord
Connector
Lower Cord
Connector
Tassel Cord
(Attached to
the Lower
Cord Connector)