HunterDouglas Silhouette Duolite Window Shadings PowerView Motorization, Установка Эксплуатация Уход

Страница: 28 / 36

OPERATION
26
Problem SoftTouch
™
only: The shading limits need to be adjusted.
Solution Adjust the Upper Limit — available for Front Shading only.
NOTE:
Programming mode timeout is 20 seconds. If there is no action within
20 seconds, programming mode exits.
■ ■
Move the shading to the fully open position (front shading and rear shade
are completely inside the headrail). See “Basic Operation” on page 14.
■ ■
Programming Mode — In two motions: push the wand up and release,
and quickly push the wand up and hold. After approximately 6 seconds
the shading will beep and a red LED behind the activator arm will blink
continuously to indicate programming mode.
■ ■
Release the wand. The upper limit is ready to be adjusted.
■ ■
Pull the wand down and release to move the front shading down. When the
desired upper limit location is reached, stop the shading. Push the wand up
and hold for approximately 6 seconds until the front shading moves slightly
twice (down, up). The red LED turns off.
■ ■
Release the wand. The shading movement indicates the new upper limit is
set and the shading exits programming mode.
Adjust the Lower Limit — available for Rear Shade only.
Vanes Closed and Vanes Open Limits are also set.
All three limits must be set in sequential order when in programming mode.
The mechanical limit is when the rear shade is at the maximum fully closed
(down) position.
If the mechanical limit is reached while the rear shade is being adjusted, the
mechanical limit will automatically become the lower limit.
NOTE: Programming mode timeout is 20 seconds. If there is no action within
20 seconds, programming mode exits.
Adjust the Lower Limit
■ ■
Move the front shading and rear shade to the fully closed (down) position.
Vanes are fully open. See “Basic Operation” on page 14.
■ ■
Programming Mode — In two motions: pull the wand down and release,
and quickly pull the wand down and hold. After approximately 6 seconds
the shading will beep and a red LED behind the activator arm will blink
continuously to indicate programming mode.
■ ■
Release the wand. The lower limit is ready to be adjusted.
(continued on next page)