Hunt HNR-3016GN, Руководство пользователя

Страница: 51 / 57

45
Input e-mail address which will receive events notification.
EVENT
Select events to be notified. When “ALL” is selected, all of the events will be notified.
SENDER Setting(SMTP Setting)
User needs to set sender to send e-mail notification.
l
SMTP : Input SMTP server address.
l PORT : Input Port number that will be used for e-mail sending.
l USER : Input User in case the log-in is required to SMTP server.
l PASSWORD : Input Password in case the log-in is required to SMTP server.
l FROM : Input sender’s e-mail address.
l E-MAIL TEST : User can check if setting is done properly or not.
NVR sends e-mail and inform you of the result.
1) It may take long depending on the SMTP server’s response time.
2) In some cases, SMTP server does not send e-mail even though the
test result is OK. Thus, please check at the receiver’s e-mail if it
receives the mail or not.
l USE SSL AUTHENTICATION
: In case the SMTP server requires SSL authentication(ex. Gmail, Yahoo
mail, etc.), select it to send e-mail after log-in with SSL authentication
Note Configuration first priority is always on “SCHEDULE” of “RECORD”.
Thus, the system will not email alarm message upon motion alarm or sensor even though
user ticks the check-box of above event selection, unless user sets the “SCHEDULE” of
“RECORD” and “MOTION”/”SENSOR” of “DEVICE” accordingly.
For example, If user sets just “Continuous” only in “SCHEUDLE” of “RECORD” and tick “All”
check-box of “REMOTE NOTIFY”, then the system will not make email notification. In this
case, user has to set “CONT + MOT”, “MOTION”, “SENSOR”, or “CON + SENS” to enable
Email Notification properly.
MOBILE NOTIFY
The system can make an event notification to the mobile device registered in the NVR.
Mobile Push Notification can be set as following steps.
1) Go to menu(Network
à Notification).
2) Click “Mobile Notify” button on the bottom.
3) Check “Use Mobile Notify” to enable Push Notification function.
4) When the mobile device is registered to the NVR correctly, it shows in the list.
Device ID is a unique ID of the mobile device.
If you want to delete it, select the device and click “Delete” button. Then, push notification setup in the
mobile device will be disabled.