Hunt HNR-3016GN, Руководство пользователя

Страница: 38 / 57

32
INTENSIVE RECODING
When alarm is triggered, system instantly assigns “remaining fps” to alarm-triggered channel and
increases recording speed during the selected dwell time, and also will trigger alarm signal via the
selected sensor-out channel. The recording speed of all other channel will remain unchanged.
DWELL (Post Alarm)
Set the recording period from the start of alarm activation. During this period, the corresponding
camera image will record according to the frame and alarm (relay) output set. The recording stops and
alarm output is turned off when the setting period is elapsed.
PRE-ALARM
Set recording period in seconds just before perceiving motion alarm.
The system records in certain seconds of time prior to the time that alarm is activated, so that user can
search video even before alarm is triggered. The pre-alarm recording mode is always “continuous” at
the recording speed that user sets in “record” of “camera” menu.
NOTIFY
User can select how to be alerted upon motion is detected by pressing “NOTIFY” button.
The system will generate buzzer sound in the selection of buzzer and/or make pop-up screen of the
camera in the selection of camera pop-up. And both notifications work together when “All” is selected.
If user doesn’t want to notify during a certain period of time, select “ALARM DISABLE TIME” and set
the time.
Note It may have some limitation depending on the Model.
3.2.5. Extra Alarm
There are several alarm functions available on the system such as SMART, VIDEO LOSS,
RECORDING FAILURE and HDD FULL.
S.M.A.R.T
It is to trigger alarm signal when HDD might be about to be out of operation.
VIDEO LOSS
It is to trigger alarm signal when the camera signal is disconnected.
RECORDING FAILURE
It is to trigger alarm signal when the system doesn’t record image due to the error in HDD or system
and so on.
DISK FULL
It is to trigger alarm signal when the HDD is occupied with a certain percentage of its capacity
If user set HDD FULL as STOP RECORDING in HDD menu and the HDD is occupied with the certain
percentage set here, NVR stops recording and alarm trigger.
Note Extra alarm will be remained in the event log only when it is set as “ON”.