3. Test 360 Imaging on the Control Head
It is important to confirm that the 360 Imaging transducer is providing sonar returns
to the display. The instructions in this section should be performed at trolling speeds
in calm, open water, in a large area that is far from shallow water, boats, or other
obstacles.
WARNING!
The pod should NOT be in the water during high speed travel. The pod
should only be deployed when the boat is traveling at trolling speeds.
Confirm 360 Imaging Sonar Operation
1. Press and hold the VIEW key.
2. Select Sonar > 360 View.
3.
Start Pinging:
Press the RIGHT Cursor key to start using 360 Imaging.
4. The sonar returns from the 360 scan will begin to display on the 360 View.
Review the display for the following information and see the illustration
Reviewing the 360 View
.
•
Bottom:
Confirm that the bottom is visible on-screen.
•
Blocked Beams:
If the beams hit a hard surface, it will appear as bright
white on the display. If the beams are blocked by any objects, move the
objects if possible or adjust the pod height (see the installation section
for more information). You can also adjust the 360 Range on the X-Press
Menu to see more or less detail on the display. In some cases, the trolling
motor will appear on the display as a shadow.
39
ct it
will
cted.
ight
this
y.
A
aging
d
Control Head Setup
TM_360_Ultrex_IG_532178-2EN_A.qxp_30895_Eng_531478 2/16/17 5:33 PM Page 39