4.
2
|
Install the Trolling Motor Bracket
Proceed to the installation section of the type of trolling motor bracket you purchased:
A. Ultrex Trolling Motor Mount (AS 360 TM Ultrex)
OR
B. Fortrex/Maxxum Trolling Motor Mount (AS 360 TM)
A. Ultrex Trolling Motor Mount (AS 360 TM Ultrex)
WARNING!
Disconnect the motor from all sources of electrical power before you
start installation.
WARNING!
Confirm that the trolling motor is properly secured to the boat and will
not shift during the installation.
Assemble the Bracket
1. The trolling motor should be in the fully retracted (flat) position on the boat
deck for this installation.
2. Disconnect the motor from all sources of electrical power.
3. In addition to the requirements listed in the
Prepare for Installation
section,
determine if the bracket will be installed on the left or right side of the
trolling motor, so the transducer pod is mounted outboard of the trolling
motor and on the centerline of the boat. Determine the mount position from
the bow, facing the (forward) direction of travel.
If the trolling motor deploys starboard side (right) on the bow,
you will
mount the bracket on the left side of the trolling motor. Position the bracket
so the straight edge faces to the left as shown in the illustration.
14
AS 360 TM Ultrex
TM_360_Ultrex_IG_532178-2EN_A.qxp_30895_Eng_531478 2/16/17 5:33 PM Page 14
