CONNECTING THE CONTROL HEAD POWER CABLE TO THE BOAT
A 6' (2 m) long power cable is included to supply power to the control head. You may
shorten or lengthen the cable using 18 gauge multi-stranded copper wire.
CAUTION:
Some boats have 24 or 36 Volt electric systems, but the control head MUST be
connected to a 12 VDC power supply.
The control head power cable can be connected to the electrical system of the boat at one
of two places: a fuse panel usually located near the console, or directly to the battery.
NOTE:
Make sure that the power cable is disconnected from the control head at the
beginning of this procedure.
1a. If a fuse terminal is available, use crimp-on type electrical connectors (not
included) that match the terminal on the fuse panel. Attach the black wire to
ground (-), and the red wire to positive (+) 12 VDC power.
1b. If you need to wire the control head directly to a battery, obtain and install an
inline fuse holder and a 2.5 to 3 Amp fuse (not included) for the protection of the
unit. Humminbird® is not responsible for over-voltage or over-current failures.
NOTE:
In order to minimize the potential for interference with other marine electronics, a
separate power source (such as a second battery) may be necessary.
You are now ready to install the transducer. Find the section that refers to your specific
transducer installation method.
TRANSDUCER INSTALLATION
There are three different installation methods for your transducer:
• Transom Transducer
• Inside the Hull Transducer
• Trolling Motor Transducer.
Find the section that describes the method of installation you will be using.
NOTE:
If the included transducer will not work for your application, you may exchange it,
NEW and UNASSEMBLED, with mounting hardware included, for a transducer appropriate
for your application - often at very little or no charge, depending on the transducer. Call the
Humminbird® Customer Resource Center (1-800-633-1468) for details and pricing, or visit
www.humminbird.com
, Product Support/Transducer Exchange for more information.
NOTE:
Due to the wide variety of hulls, only general instructions are presented in this
installation guide. Each boat hull represents a unique set of requirements that should be
evaluated prior to installation. In addition to the parts supplied, you will need a hand drill
with various bits, a socket wrench (5/16"), a Phillips head screwdriver, and marine-grade
silicone sealant.
NOTE:
When drilling holes in fiberglass hulls, it is best to start with a smaller bit and use
progressively larger drill bits to reduce the chance of chipping or flaking the outer coating.
Fill all holes with marine grade silicone sealant.
WARNING:
Do not touch an active transducer during operation, as this may cause physical
discomfort and may result in personal injury in the form of tissue damage. Handle the
transducer only when the power to the control head is off.
GROUND
POSITIVE
10
531374-1_A - 947 Man.qxd 2/15/2005 7:53 PM Page 15
