www.humancaregroup.com
27
ENGLISH
Suspending the lift from the rail
HeliQ is mounted directly in the rail roller, which
is located in the rail. Do not use any distance
strap or similar.
Remove the pins (A) holding the two bolts (B) to
the rail roller. Remove the bolts and raise the lift
to the rail roller. Make sure that the holes in the
connector on the lift and the holes in the rail
roller are lined up, and replace the bolts in the
holes. Secure the bolts with the two pins. The
lift can be mounted in either direction. Switch
on at the mains and the lift is ready for use.
A
B
emergency lowering button only works when
the lift is switched on and emergency stop
has been deactivated. When the emergency
lowering is active, the end position switches are
inactive. If the button is pushed until the lift is
in its lowest position, the lift will start to go up
again. Always stop at the lowest position.
The emergency lowering button
must only be used in emergency
situations.
Safety catch
The lift is equipped with a safety catch. This
prevents involuntary falls. If the lift belt is pulled
out too quickly, the safety catch will engage,
thus preventing the fall.
Mechanical emergency lowering
During power loss and the hoist is loaded,
user in the hoist, the mechanical emergency
lowering is activated and the hoist is lowering in
a safe and reliable manner.
Overheating
The lift has overheating protection which stops
the motor if it gets too hot. Overheating can
occur if the motor is overloaded or operated
continuously for quite a long time. The lift’s
work cycle (work:pause) is 15:85. Maximum
continuous operation is two minutes. If this is
exceeded, there is a risk of the motor overhea-
ting.
Belt tension guard
The lift is equipped with a belt tension guard
that prevents unintentional discharging of the
lift belt. It must be loaded in order to be able to
pull the belt out. Pull gently on the belt while at
the same time pressing the Down button on the
hand control or control panel. The weight of the
bar is sufficient for the belt to be fed out.