Range of values
Typical values
Parameter
Not applicable (parameter reserved
for future use).
OK
Receive Path Fault
Any whole number.
≥ 0
RX Error
Traffic Statistics: Receive
Any whole number.
≥ 0
Total Satellite Packets Received
Any whole number.
≥ 0
CONUS Packets Received
Any whole number.
≥ 0
PTP Packets Received
Any whole number.
≥ 0
Unicast Data IP Datagrams
Any whole number.
≥ 0
Multicast IP Datagrams
Any whole number.
≥ 0
Management and Signaling IP
Datagrams
Any whole number.
≥ 0
Satellite Packets Dropped
Any whole number.
≥ 0
Frames With No Signal
Any whole number.
≥ 0
Number of TIPS Received
Red flags on Reception Information page
A red flag next to a value on the Reception Information page indicates a problem related to the
parameter listed in the same row where the flagged value appears. For explanation, find the
flagged parameter in this table.
If a state code is displayed next to the parameter,
refer to
on page 35 identify the probable cause and possible solution.
Table 8: Red flags on Reception Information page
Possible solutions
Probable cause
Flagged parameter
See
on page
35. Most of these problems must
be corrected by a qualified installer.
Various causes are indicated by
state codes 26–35.
Receive Status
There is a problem with the
configured latitude and longitude.
Probing failure (occurs only during
commissioning).
Make sure the entered latitude and
longitude values are correct and in
the correct format. This problem
must be corrected by a qualified
installer.
The problem must be corrected by
a qualified installer.
Registration failure (occurs only
during commissioning).
Make sure the receive cable is
tightly connected to the router’s rear
No Beacon (or)
SQF of 0 or 1.
Receive Signal Strength
panel. Any other cable connections
must be checked by a qualified
installer.
HN9500 Satellite Router User Guide
26
1037737-0001 Revision E
System Control Center
Chapter 2