14
Using the Hughes 9211
3500988-0001 Revision A
If you have a device that supports voice and 3.1 KHz/fax on a
single line, you can configure the RJ14 port to support both
services on line 1. On the
Telephony Settings
page, set the
field “
Route incoming 3.1kHz/fax calls to
” “
RJ14 port 1
”
and simply connect the device directly to the RJ14 port with an
RJ11 cable. With this setting, all incoming calls are then
routed to RJ14 line 1.
To initiate an outgoing 3.1kHz/fax call when connected to line
1, add a 2* prefix in front of the dialed number. For voice
calls, no prefix is required, but the 9211 will accept a 1* prefix
to indicate a voice call.
To receive incoming calls on line 1, change the Route
incoming 3.1KHz/fax calls parameter on the Telephony
Settings page to “RJ14 Line 1” using the drop down menu.
Dialing and Numbering
Dialing
- As the BGAN numbering system follows the same
pattern as the normal telephone system, dialing is carried out
in exactly the same manner as making a normal telephone call.
The subscriber number is used with the same international and
area codes as any other telephone network. Start the dialed
number with 00 and terminate it with #. If you are calling
another BGAN unit, you need to dial 00 then the 870 number
and then # to initiate the call.
To dial, prefix the international number with 00 and terminate
with #. For example, to dial a number in the USA, enter:
0018005551234# (00 + Country code + phone #)
External Antenna
The 9211 terminal has an external antenna port that can be
used (with a future software release) to connect the existing
mobile antennas for Class 10 and Class 11 so that they can be
used with the 9211 terminal to get comms-on-the-move
(legacy data rates). Hughes is developing a Class 1 active
antenna for use with the 9211 terminal that will provide
asymmetric HDR data rates.
