Pub. 42004-467D
Camera Telephone Manual
Page 21 of 30
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-467D.docx
04/19
Ring-down Operation
Ring-down operation enables the telephone to go off-hook when the
HELP
push button is pressed. The
ring-down system must detect loop current and ring-down to the appropriate telephone.
Password Protection
The password protection feature allows changing the four-digit password required to program the
telephone. Each telephone is password protected to maintain the integrity of programmed information
and should not be disabled.
The password is required to enter the programming mode when programming the telephone locally or
from a remote location. Jumper
J9
must be in the
EN
position to enable the password protection feature.
Complete the key sequence to change the four-digit password.
Table 4. Password Programming
Feature
Key
Sequence
Description
Default
Password
Protection
# 1 4
N N N N
A four-digit password must be supplied to remotely
program the telephone. If the password has been changed
and programming mode can’t be accessed (see Password
Disabled Programming section).
Example
: To program the password
1234
, enter
# 1 4 1
2 3 4
.
2468
Auto-Answer Alert
When auto-answering an incoming call, the RED ALERT
®
telephone will generate a splash tone on the
telephone line. This tone is always heard by the calling party. This tone can be pre-programmed to also
be heard over the telephone’s integral speaker using this key sequence.
Table 5. Auto-Answer Alert Programming
Feature
Key
Sequence
Description
Default
Auto-answer
Alert
# 1 6
L
The auto-answer alert feature allows a person to call the
emergency telephone and monitor the area around the
telephone with or without sounding a splash tone over the
unit’s integral speaker.
(Disable alert tone),
L
=0.
(Enable alert tone),
L
=
1
.
1 (Enabled)
Off-Hook Ringing
The telephone can generate a ringing signal from the speaker when the telephone is called. The factory
default setting for this feature is
disabled
.
N
OTE
:
In addition to enabling this feature, the auto-answer feature must also be enabled for proper
operation.
