Pub. 42004-467D
Camera Telephone Manual
Page 18 of 30
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-467D.docx
04/19
TIME (s)
SIG
N
A
L
(mV)
SPLASH
TONE
SUCCESS
TONE
DTMF
PASSWORD
DIGITS
SUCCESS
TONE
SUCCESS
TONE
DTMF
PROGRAMMING
SEQUENCE
DIGITS
APPROX
1.5 s
LOW
TONE
HIGH
TONE
Figure 14. Telephone Programming Timing Diagram
Programming Sequences
The information on the following pages explains the programming
options. The telephone is shipped from the factory with default
parameters configured (see Table 2). A column is included in the table
to record the modified programming parameters.
The following instructions are common to both local and remote access programming. Follow these
directions to configure the telephone to the desired operating parameters.
1.
Connect to the telephone locally (see the Local Access Programming section) or remotely (see the
Remote Access Programming section).
2.
Dial the factory-default password
2468
(or appropriate customer-selected password). A success tone
(short beep) is generated to indicate that
standard
programming mode has been accessed.
3.
After hearing the password success tone, begin entering each desired programming key sequence (see
the Programming Sequences section).
A success tone (short beep) is generated each time a new key sequence is accepted.
An error tone (two low tones) is generated to indicate errors.
4.
Verify the key sequence and reenter the sequence if an error tone is generated.
Programming Legend
D = digit 0–9, *, or #
N = digit 0–9
L = 0—Disable; 1—Enable
