Page
4 of 26
Model 298 ADA-Compliant Emergency Telephone
Pub. 42004-304A
f:\standard ioms - current release\42004 instr. manuals\42004-304a.doc
06/02
Acknowledgment of the call causes the telephone to perform two functions: illuminate the
C
ALL
R
ECEIVED
W
HEN
L
IT
lamp on the front panel and transmit a user-programmed three-digit location identification code.
The emergency telephones can also be used to make non-emergency type calls. Non-emergency telephone
communication can be made by pressing the
C
ALL
push button, waiting for dial tone, and using the keypad
to dial the desired number. To disconnect the call, press the
C
ALL
push button a second time.
Installation
The following sections provide information for installing the Model 298 Telephone.
SAFETY GUIDELINES
When installing any GAI-Tronics telephone equipment, please adhere to the following guidelines to ensure
the safety of all personnel:
•
NEVER install telephone wiring during a lightning storm.
•
NEVER install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
•
NEVER touch uninsulated telephone wires or terminals unless the telephone line has been disconnected
at the network interface.
•
USE CAUTION when installing or modifying telephone lines.
INSTALLATION GUIDELINES
•
GAI-Tronics’ emergency telephones are not designed to be installed in parallel or to be “party-lined.”
Any such installation can cause programming difficulties, premature disconnection of calls, or stations
that may not respond when activated. GAI-Tronics highly recommends that one telephone line (PBX
extension or CO line) be allocated for each unit.
•
GAI-Tronics highly recommends that a telephone line surge suppressor be installed to guard against
lightning strikes. Please consult our Service Center at 800-523-4303 if further information is required.
•
Sealed fittings should be installed at all cable entry points to prevent liquids from entering the unit.
MOUNTING AND WIRING INSTRUCTIONS
1.
Loosen the 6 tamper-resistant screws from the front panel assembly using the GAI-Tronics Model
233 Tamper-Resistant Screwdriver (sold separately).
2.
Disconnect the front panel assembly from the back box by unplugging the modular line cord from the
modular wall jack (located in the back box).
