13
1.7 After check all the above parts is ok, if still could not start up, check below,
Take out ignition high voltage cap, unscrew the 2 screws, take out
swirl pole
,
Put finger into the hole where
swirl pole
have been taken out.
Keep put finger into the hole, use left hand to pump air pump, then use finger to feel
whether if there have gasoline spray out, if do not have, rotate Adjust Knob of carburetor
to increase power a little bit until finger could feel there have gasoline spray out.
2. After start up machine, turn on solution tap, if does not spray fog, check below,
2.1 Check air line,
Open chemical tank lid, put hand on it to feel whether there have pressure, if do not have
pressure, check below,
Check whether the chemicals solution screw is jammed? Get through it, then fix back
appropriately.
