User Manual
Quidway W1003 Series Wireless Access Device
WA1003A-RU Wireless ADSL Access Point
Chapter 2 Installation
2-6
Table 2-1 Information you will need from your ADSL service provider
Username
This is the Username used to log on to your ADSL service
provider’s network. It is commonly in the form
−
[email protected]. Your ADSL service provider uses this to
identify your account.
Password
This is the Password used, in conjunction with the Username
above, to log on to your ADSL service provider’s network.
This is used to verify the identity of your account.
Connection
Protocol
This is the method your ADSL service provider uses to send
and receive data between the Internet and your computer.
Your Modem supports the following connection protocols:
PPPoE, PPPoA, PPPoA with DHCP, Bridge, and CLIP
(IPoA).
Modulation
Type
ADSL uses various standardized modulation techniques to
transmit data over the allotted signal frequencies. Some
users may need to change the type of modulation used for
their service. The default DSL modulation (MMODE) used for
the WA1003A-RU automatically detects all types of ADSL
modulation. However, if you are instructed to specify the
modulation type used for the WA1003A-RU, you have three
alternatives: G.LITE, G.DMT and T1.413
Security
Protocol
This is the method your ADSL service provider will use to
verify your Username and Password when you log on to their
network. Your Modem supports the PAP and CHAP
protocols.
VPI
This is the Virtual Path Identifier (VPI). It is used in
conjunction with the Virtual Channel Identifier (VCI) below, to
identify the data path between your ADSL service provider’s
network and your computer.
VCI
This is the Virtual Channel Identifier (VCI). It is used in
conjunction with the VPI above to identify the data path
between your ADSL service provider’s network and your
computer.
