Installation Manual
Quidway S3026C-PWR Ethernet Switch
Chapter 5 Loading BOOTROM and Host Software
Huawei Technologies Proprietary
5-12
<Quidway> boot bootrom SWITCH.btm
please wait ...
Bootrom is updated!
Step 3: Load host software.
<Quidway> boot boot-loader SWITCH.app
<Quidway> display boot-loader
The app to boot at the next time is: flash:/SWITCH.app
<Quidway> reboot
(Make sure the configurations have been saved before rebooting the switch, for it
may cause lost configurations.)
After these steps you have finished loading Boot ROM and host software. Note that
you must reboot the switch to make a successful loading of host software. In the
event of insufficient flash memory, you can first load Boot ROM. Then delete some
program files (obsolete host software files are recommended) in the flash memory
and load the new host software using FTP. No power-off is allowed during this
process.
5.3.2 Using TFTP
Using TFTP is similar to using TFP, but it should be noted that the switch only can
sever as TFTP client and that the files can only be downloaded to the flash memory
of the switch.
5.4 Remote Loading of PoE Card
Quidway S3026C-PWR Ethernet Switch supports remote loading of PoE card. The
switch first downloads application using FTP or TFTP, and then loads the PoE card.
After logging into the switch, you can load the PoE card through these two steps:
Step 1: Downloads the PoE card application onto the switch using FTP or TFTP.
Step 2: Loads card application using the command line.
The following introduces the loading procedure of the PoE card by taking the local
PC as the FTP server and the switch as the FTP client.
The configuration of the switch is presumed as follows: FTP user name is switch,
with the password of hello; the user is authorized with the read-write authority; the IP
address of the VLAN interface on the switch is 1.1.1.1, the IP address of the PC is
2.2.2.2, and the route between the switch and the PC is reachable. PoE card
application new.bin is stored on the PC.
