Installation Manual
Quidway S3026C-PWR Ethernet Switch
Chapter 2 Installation Preparation
Chapter 2 Installation Preparation
2.1 Precautions
To avoid any device impairment and bodily injury because of improper use, please
follow the precautions listed below:
z
Before cleaning the switch, please unplug the switch connector first. Do not
clean the switch with wet cloth or with liquid.
z
Do not place the switch near water or any damp area. Prevent water or
moisture from entering the switch chassis.
z
Do not place the switch on the unstable cases or desks, as the switch might be
damaged severely in case of a fall.
z
Ensure proper ventilation of the room and keep the switch ventilation hole free
of obstruction.
z
The switch can operate normally under correct voltage input. Make sure that
the operating voltage is consistent with that labeled on the switch.
z
Do not open the chassis while the switch is in operation to protect the safe of
the operator and the switch.
z
Before changing I/O board, wear ESD-protective gloves for fear of damaging
the board with ESD.
2.2 Requirements on Environment
S3026C-PWR must be used indoors. The following conditions must be met
regardless of whether you install the switch in a 19-inch standard cabinet or install it
directly on a tabletop.
z
Make sure that enough room is left for the air-intake hole and the ventilation
hole of the switch, so that the heat dissipation of the switch chassis can be
guaranteed.
z
Make sure that the ventilation and heat dissipation systems of the cabinet and
the tabletop are good.
z
Make sure that the cabinet and the tabletop are stable enough to bear the
weight of the switch and the accessories.
z
Make sure that the cabinet and the tabletop are well grounded.
To ensure normal operation and to prolong the life span of the switch, the following
requirements on the installation site must also be satisfied.
Huawei Technologies Proprietary
2-1
